Se rendre au contenu

STD-UI1 — single-phase meter

Member of the rbAmp STD family; everything on the family page applies.


What it is

A single-phase precision energy meter module: one voltage and one current input with synchronous sampling, the full STD feature set, and a choice of I²C or Modbus RTU. Variant code 0x11.

It works as a sub-meter / smart-meter front end for a master (ESP32, Arduino, Raspberry Pi, PLC), or directly on a Modbus RTU network (through an external RS-485 transceiver) as a meter, including a float32 register profile of 13 values for inverters and monitoring systems (Modbus transport).


Key properties

Inputs 1 voltage, 1 current (factory-matched sensor, labelled for the channel; 60 A or 100 A in the kit)
Quantities U, I, P (signed), Q, S, PF (signed), frequency; import/export energy, active and reactive
Energy counters Wh, mWh, µWh (active) and varh, µvarh (reactive); kept when the power is off
Interfaces I²C (0x50 by default) or Modbus RTU (unit 1, 9600 8N1 by default), chosen by the interface mode switch
Snapshot cadence a complete snapshot about ten times a second; data-ready output
Period snapshots eight independent banks
Update over the working bus, with automatic rollback

Measured characteristics

Measured on one production module per kit (60 A and 100 A), each channel individually calibrated together with its sensor, against a reference meter on a resistive load. Current is given as the primary current with one pass of the wire through the sensor; on STD-U3I3 the figures cover all three channels.

Parameter 60 A kit 100 A kit
Current error ±0.2 % in range 0.005 A – 75 A ±0.2 % in range 0.005 A – 100 A
Upper end of the range 75 A 129 A
Voltage error ±0.2 % ±0.2 %
Power factor, resistive load 0.999–1.000 0.999–1.000
Reads from 4.8 mA 4.8 mA
Noise with no current 0.2 mA 0.35 mA

Typical uses

  • The main meter of a single-phase home, apartment or workshop.
  • Sub-metering of a circuit, a heater, an EV charger or a heat pump.
  • Solar self-consumption: separate import and export energy, the float32 profile points for a Modbus master.
  • A measuring node in a Home Assistant / ESPHome installation.

Where to go next

Hardware · Getting started · Real-time polling · Energy and periods · Technical reference