Solution · Home Assistant
Your Energy dashboard needs per-circuit sensors — the whole-house meter is one line
rbAmp gives Home Assistant voltage, current, power and energy for each circuit as ordinary sensors — a few lines of YAML with the ESPHome component, or a Raspberry Pi over MQTT. Works with the HA Energy Dashboard.
What you get in Home Assistant
Ordinary HA sensors
Voltage · Current · Power · PF · Frequency · Energy appear as ordinary HA sensors — graphs, history, automations.
HA Energy Dashboard
Energy flows into the built-in Energy Dashboard: daily/tariff totals, long-term statistics, cost. (BASIC: consumption only. STD: import and export as separate energy sensors, for Grid consumption and Return to grid.)
Per-circuit / multi-module
Several modules on the bus → separate loads (water heater, kitchen, mains) as separate entities.
Automations & alerts
Thresholds, notifications, scenes — overload, "left the iron on", export to the grid (STD).
Choose your path
| ESPHome (ESP32) | SBC direct (Raspberry Pi) | |
|---|---|---|
| Hardware | ESP32 | Raspberry Pi |
| Effort | YAML, no code | Python + MQTT |
| Best for | Everyone | Integrators · headless |
Path A — ESPHome component
ESPHome on the ESP32 → a short YAML block → sensors in HA.
- Flash ESP32. ESPHome firmware on the ESP32; module on I²C (SDA/SCL; the DRDY line is optional), powered at 5 V.
- Add the component.
external_components, anrbampblock (address, clamp model) andplatform: rbampsensors. - Entities appear. U / I / P / PF / Hz / energy show up in HA automatically; drop them on a dashboard.
i2c:
sda: GPIO21
scl: GPIO22
frequency: 50kHz
external_components:
- source: github://rb-amp/rbamp-esphome@main
rbamp:
id: meter1
address: 0x50 # factory default
ct_model: SCT_013_030 # your clamp model
sensor:
- platform: rbamp
rbamp_id: meter1
voltage: { name: "Mains Voltage" }
power: { name: "Mains Power" }
energy: { name: "Mains Energy" }- No code — pure YAML
- Multi-module on one bus
- The energy total survives reboots — saved on the ESP32 and restored before the first update, so HA sees no reset
- ESPHome's own API to HA (not MQTT)
Path B — SBC direct (Raspberry Pi)
Module on the Pi's I²C → pip install rbamp smbus2 → MQTT autodiscovery → entities in HA.
- Wire to the Pi. Module on the Pi's I²C (SDA/SCL, 3.3 V logic), powered at 5 V; enable I²C in raspi-config.
- pip install rbamp smbus2. Read U / I / P / PF / Wh in Python.
- Bridge to HA. Publish to MQTT with autodiscovery → HA creates the entities itself.
from smbus2 import SMBus
from rbamp import RbAmp
with SMBus(1) as bus, RbAmp(bus, 0x50) as dev:
print(dev.voltage, dev.read_current(0), dev.read_power(0)) # V, A, W- For headless / Pi-centric / integrator setups
- No ESP32 required
- 3.3 V logic — no level shifter
- Full MQTT discovery example in the docs
Get rbAmp into Home Assistant.
Follow the guide for your path: ESPHome on an ESP32, or Python on a Raspberry Pi.